不锈钢过滤器滤芯维护与保养应该注意什么? - 山东多介质过滤器哪家好
欢迎光临!济南联众供热设备厂,主营:山东燃气锅炉山东电采暖锅炉山东多介质过滤器和射线防护器材等。
  • 服务热线:18678809986
  • 娱乐宝彩票注册 关于我们 产品中心 娱乐宝彩票注册中心 工程案例 设备选型 娱乐宝彩票注册
  • 您的位置:娱乐宝彩票注册> 娱乐宝彩票注册中心 >

    不锈钢过滤器滤芯维护与保养应该注意什么?
    来源:http://www.apzhuoyou.com 发布时间:2020-06-29

    1.不锈钢过滤器长期未得以应用时,我们必须要将过滤器内部的滤液排放干净,然后将滤芯拿出,进行洗净烘干流程,当完成这一系列操作后,将产品放入干净的塑料袋内并封口,这是为了保证滤芯产品不被污染.,将不锈钢过滤器擦净存放于干燥处即可.
    1. When the stainless steel filter has not been used for a long time, we must discharge the filtrate inside the filter, and then take out the filter element for cleaning and drying process. After completing this series of operations, put the product into a clean plastic bag and seal it to ensure that the filter element product is not polluted. Finally, clean the stainless steel filter and store it in a dry place
    2.一般,换下来的滤芯要浸泡于酸性强度强的洗液中,浸泡时长约为24小时左右,切记,酸性液体的温度要保持于25-50度左右,在进行浸泡的过程中时,我们建议酸与碱占液体的比例要控制在20%之间,这是为了避免液体对滤芯产品内部的破坏与污染.
    2. Generally, the replaced filter element should be immersed in strong acid detergent for about 24 hours. Remember that the temperature of acid liquid should be kept at about 25-50 degrees. In the process of soaking, we suggest that the ratio of acid and alkali to liquid should be controlled between 20%, which is to avoid the damage and pollution of the liquid to the filter element
    山东多介质过滤器
    3.一般而言,蛋白因子较高的洗液产品好,不管是从清洁度上还是节约上而言,效果都很好.因此,应当利用蛋白含量较高的酶溶液进行清洗.当清理过后,一定要进行二次清洗,并采用蒸汽进行整体消毒,这流程对过滤器的保养更为重要.
    3. Generally speaking, the detergent with high protein factor is good, and the effect is good both in terms of cleanliness and economy. Therefore, enzyme solution with high protein content should be used for cleaning. After cleaning, it is necessary to carry out secondary cleaning and steam disinfection, which is the most important process for the maintenance of the filter
    4.不锈钢过滤器在消毒过程中要注意一定的时间和温度,通常,内部的滤芯产品要在消毒柜中放置130℃/20分钟,消毒温度不宜超过150℃,更长消毒时间不能超过30分钟.要切记,一旦消毒温度过高,抑或时间长、压力大,都会导致过滤器内部元件(滤芯)的整体损坏.
    4. Pay attention to certain time and temperature in the process of disinfection of stainless steel filter. Generally, the internal filter element should be placed in the disinfection cabinet at 130 ℃ / 20 minutes. The disinfection temperature should not exceed 150 ℃ and the longest disinfection time should not exceed 30 minutes. It should be noted that once the disinfection temperature is too high, or the time is long and the pressure is high, the internal components (filter element) of the filter will be damaged
    本文由山东多介质过滤器提供技术支持,更多的详细精彩内容请点击http://www.apzhuoyou.com我们的网站,我们将会全心全意为您提供满意的服务
    This paper is supported by Shandong multi-media filter. For more details, please click http://www.apzhuoyou.com Our website, we will wholeheartedly provide you with satisfactory service

    鲁公网安备 37011302000227号

    网上手机网投游戏 浙江福彩网 手机网投网址大全 彩票手机网投 博盈彩票开户 浙江11选5 手机网投 网上投注平台出租 彩票手机网投 恒发彩票